The Digilent Pmod AD1 is a two channel, 12-bit analog-to-digital converter that features Analog Devices AD7476A . With a sampling rate of up to 1 million samples per second, this Pmod is capable of excelling in even the most demanding...

The Pmod HAT Adapter makes it easy to connect Pmods to a Raspberry Pi. It supports plug-and-play functionality, only requiring that the host Raspberry Pi is booted with the Pmod HAT attached. The Pmod HAT has three 2×6 Pmod ports and...

The Pmod ACL2 is a 3-axis MEMS accelerometer powered by the Analog Devices ADXL362 . By communicating with the chip via the SPI protocol, users may receive up to 12 bits of resolution for each axis of acceleration. Additionally, this...

The Digilent Pmod 8LD has eight high-brightness LEDs that are driven by logic level transistors so that each LED can be individually illuminated from a logic high signal. Features: Eight high-brightness green LEDs Uses BJTs for low-power...

The Digilent Pmod LVLSHFT is a digital logic level shifter that uses the Texas Instruments SN47LVC1T45 tranceiver. This module is ideal for users who want to supply logic signals following a 3.3V CMOS standard but have an alternate logic...

The Digilent Pmod JSTK2 is a versatile user input device that can be easily incorporated into a wide variety of projects. With an on board Microchip PIC16 MCU , two-axis joystick on a center button, a trigger button, and a programmable...

The Pmod HYGRO is a relative humidity sensor with integrated temperature sensor for highly accurate measurements at low power. With the TI HDC1080 , you can determine the relative humidity of the environment with up to 14 bits of...

The Pmod SSR is a solid state relay that features IXYS' CPC1908J. The Pmod SSR uses a switch controlled by a single GPIO pin and is rated to block up to 48 Volts and switch up to 6 Amps (rms) continuous current. Features: 0-48 V blocking...

The Basys 3 is an entry-level FPGA development board designed exclusively for Vivado Design Suite , featuring Xilinx Artix-7 FPGA architecture. Basys 3 is the newest addition to the popular Basys line of FPGA development boards, and is...

The joint test action group (JTAG) HS2 programming cable is a high-speed programming solution for Xilinx ® field-programmable gate arrays (FPGAs). The cable is fully compatible will all Xilinx tools and can be seamlessly driven from...

The Arty Z7 is a ready-to-use development platform designed around the Zynq-7000™ All Programmable System-on-Chip (AP SoC) from Xilinx. The Zynq-7000 architecture tightly integrates a dual-core, 650 MHz ARM Cortex-A9 processor with...

The Pmod SF3 provides users with 32 MB of non-volatile memory through the use of Micron's NOR Flash memory ( N25Q256A ). By using the SPI protocol, users can both write to and read from the flash memory. Features: 32 MB serial NOR Flash...