Top seller
No results were found for the filter!
European Wall Plug Adapter Features: Convenient way to switch from US wall plug to European or UK wall plugs Simple snap-on design Used with Digilent's switching power supplies US to European wall plug adapter
₹ 339.00 *
UK Wall Plug Adapter Features: Convenient way to switch from US wall plug to European or UK wall plugs Simple snap-on design Used with Digilent's switching power supplies US to UK wall plug adapter
₹ 399.00 *
ZedBoard Zynq-7000 ARM/FPGA SoC Development Board ZedBoard is a low-cost development board for the Xilinx Zynq - 7000 all programmable SoC (AP SoC). This board contains everything necessary to create a Linux ® , Android ® , Windows ® , or other OS/RTOS based design. Additionally,...
₹ 57,999.00 *
Pmod ISNS20: 20A Current Sensor The Digilent Pmod ISNS20 is a small current sense module with a digital SPI interface. The board combines an Allegro ACS722 Hall Effect current sensor with a 12-bit analog-to-digital converter from Texas Instruments. The Pmod ISNS20 is...
₹ 1,709.00 *
Impedance Analyzer for Analog Discovery The Impedance Analyzer for Analog Discovery was designed with automatically adjusting reference resistors and relays to aid in use of the Impedance Analyzer tool in WaveForms. With the Impedance Analyzer accessory, the Analog Discovery...
₹ 2,529.00 *
BNC Adapter Board for the Analog Discovery The Discovery BNC adapter board is intended to be used with the Analog Discovery™ tool to enable the use of standard BNC-terminated test leads and probes. It provides BNC terminations to each of the two oscilloscope channels on the...
₹ 2,409.00 *
Pmod Cable Kit: 2x6-pin and 2x6 Pin to Dual... This kit is a handy accompaniment to your 12-pin Pmod. The extension cables let you locate your Pmod 6" away from its host board, or use your 12-pin Pmod on a system board with only two 6-pin Pmod headers available. We've also included...
₹ 729.00 *
Pmod TC1: K-Type Thermocouple Module with Wire The Digilent Pmod TC1 is a cold-junction thermocouple-to-digital converter module designed for a classic K-Type thermocouple wire. With Maxim Integrated's MAX31855, this module reports the measured temperature in 14-bits with 0.25°C...
₹ 2,799.00 *
Pmod TMP3: Digital Temperature Sensor The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A . Users may configure the output through I 2 C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature...
₹ 1,349.00 *
Pmod SSD: Seven-segment Display The Pmod SSD is a two-digit seven-segment display. Users can toggle through GPIO signals which digit is currently on at a rate of 50 Hz or greater to achieve persistence-of-vision to give the effect of both digits being lit up...
₹ 749.00 *
Pmod RTCC: Real-time Clock / Calendar The Pmod RTCC is a real-time clock/calendar powered by the Microchip ® MCP79410. Through the I 2 C interface, users may configure up to two alarms that can be triggered at a wide variety of possible times. Note: The Pmod RTCC is also...
₹ 1,549.00 *
Pmod R2R: Resistor Ladder D/A Converter The Pmod R2R is resistor ladder with a R-2R resistor configuration. Users can provide 8-bits of parallel data to the module through GPIO signals. This setup teaches users the basic principles behind a Digital-to-Analog Converter....
₹ 569.00 *
Nexys A7-50T Pmod MicroSD Analog JTAG-SMT2-NC HDMI Cable Type Analog Eclypse Z7 PYNQ-Z1 Stepper Motor Zybo Z7 Pmod ACL 3-axis Pmod AMP2 Audio Pmod OD1 Open MCC 134 Analog Analog Pmod ENC Rotary Arty S7-25T Enclosure Kit Arty A7-35T Arty A7-100T NI Multisim Pmod NIC100 MCC 128 Voltage Cmod A7-15T Eclypse Z7 Pmod NAV 9-axis NI myRIO ZedBoard Basys 3 Artix-7 Nexys Video Analog Pmod RS232 Pmod HAT Analog Cora Z7-10 Zybo Z7-20 Genesys ZU-5EV Zybo Z7 Pmod ISNS20 20A XUP USB-JTAG SMA to Nexys Video NI myRIO Cmod A7-35T Cora Z7-07S
Viewed