Top seller
No results were found for the filter!
RF Meter click RF Meter click is a radio frequency power measurement device covering a frequency span from 1 MHz to 8 GHz over a 60 dB range (approximately). It enables monitoring and measuring frequency levels to ensure proper functioning and leak...
₹ 6,599.00 *
10DOF click 10DOF click is a mikroBUS add-on board for enhancing hardware prototypes with 10DOF functionality (10 degrees of freedom). The click board carries two modules from Bosch: BNO055 , a 9-axis absolute orientation sensor and BMP180 , a...
₹ 5,149.00 *
Heart rate 4 click Heart rate 4 click carries the MAX30101 high-sensitivity pulse oximeter and heart-rate sensor from Maxim Integrated. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target MCU over I2C interface,...
₹ 4,359.00 *
Stretch click Stretch click is a mikroBUS™ add-on board with circuitry for measuring stretch forces with conductive rubber cords. The click has screw terminals for connecting 2mm-diameter conductive rubber cord. The resistance of the cord increases...
₹ 8,349.00 *
Ozone 2 click Ozone 2 click carries an MQ131 sensor for Ozone (O 3 ). The sensor outputs an analog voltage, which is converted by the onboard MCP3551 22-bit ADC converter or it is sent to the microcontroller via AN pin on the mikroBUS™, depending on...
₹ 10,339.00 *
Compass 2 click Compass 2 click carries the AK8963 3-axis electronic compass. The AK8963 sensor is based on the Hall effect. The click is designed to run on a 3.3V power supply only. It communicates with the target microcontroller through either I2C or...
₹ 2,629.00 *
RTD click RTD click is based on MAX31865 resistance to digital converter from Maxim Integrated , optimized for platinum resistance temperature detectors, or RTD. The click uses the PT100 type platinum probe for temperature measurement. There are...
₹ 2,869.00 *
Thermo J click Thermo J click is a temperature measurement click board™, which uses a thermocouple type-J probe, connected to a PPC-SMP-J onboard connector. The active part of the Thermo J click is MCP9600 by Microchip - a thermocouple EMF to...
₹ 5,979.00 *
DHT22 2 click DHT22 2 click is used for measuring the environmental temperature and relative humidity. It uses the CM2322 sensor, with very accurate thermal and humidity measuring capabilities. It can use either 1-Wire or I2C protocol to communicate...
₹ 3,239.00 *
Proximity 3 click Proximity 3 click is an intelligent proximity and light sensing device, which features the VCNL4200 sensor from Vishay - high sensitivity long distance proximity sensor (PS), ambient light sensor (ALS) and 940 nm IRED, all in one small...
₹ 2,489.00 *
Microwave click Microwave click detects movement, thanks to the PD-V11 a 24GHz microwave motion sensor. The typical use for Microwave click is a proximity or motion detector in various applications and devices. The Microwave click can detect movement or...
₹ 3,739.00 *
Water Detect click Water Detect click is used for detecting water and other electroconductive liquids. If the detection area is wet the output of Microchip's MCP606 CMOS op-amp will go positive, signaling the presence of liquid. Water Detect click can be...
₹ 1,369.00 *
Slider click UV 4 click 6DOF IMU click Temp-Log 5 Ambient 5 click Air quality 3 TMR Angle Click Pressure 7 Accel 7 click Proximity 7 Temp-Log 2 6DOF IMU 11 Heart Rate 9 IR Grid 2 click 9DOF click Ultrasonic 2 MAGNETO 2 click UV 3 click SHT click Alcohol click Heart rate 6 Pedometer 3 Heart Rate 7 Temp Hum 9 Pressure 9 Tilt 2 Click Thermo J click Spectral 2 Hall Current 3 Barcode Click Accel 12 click Angle 3 click LightRanger 4 Hall Current 6 IR Sense 2 Hall Current 4 RTD click Pressure 4 Gyro 3 click MOTION click THERMO 2 click THERMO click IrDA 3 click EMG click 13DOF Click Compass 2 click
Viewed