Top seller
No results were found for the filter!
ADAC click ADAC click is an 8-channel 12-bit ADC, DAC and GPIO. It carries the AD5593R configurable ADC/DAC. The click is designed to run on either 3.3V or 5V power supply. ADAC click communicates with the target microcontroller over I2C interface,...
₹ 2,729.00 *
AC Current click AC Current click can measure alternating currents up to 30A and it features the MCP3201 ADC (analog to digital) converter and the MCP607 CMOS Op Amp, both from Microchip. The click is designed to run on either 3.3V or 5V power supply. It...
₹ 1,469.00 *
R Meter click The analog output is fed through a 12-bit ADC with the final output going through the mikroBUS™ SPI interface. Since the ADC has a limited min-max range (0-2043), R Meter click employs a multiplexer that can adjust the input signal to...
₹ 2,839.00 *
Ammeter click Two onboard screw terminals (probe+ and probe-) are bringing in the current, which then passes through a shunt resistor. A voltage proportional to the strength of the current is generated accross the resistor. This voltage passes through...
₹ 2,519.00 *
C Meter click The chip is implemented in an astable multivibrator circuit with fixed resistors and adjustable capacitors. The board has four different-sized plates for placing SMD capacitors (covering standard SMD packaging dimensions) as well as a...
₹ 949.00 *
DIGI POT 2 click DIGI POT 2 click is a mikroBUS™ add-on board with a single channel digital potentiometer TPL0501 with 256 wiper positions. The IC has 100 kilo Ohms end-to-end resistance, with ±20% tolerance. The board features two pairs of screw...
₹ 1,779.00 *
DAC 3 Click DAC3 click carries Microchip’s MCP4726 IC, a 12-bit digital-to-analog converter, along with voltage output screw terminals. The digital value is converted to the appropriate voltage level in the range between GND and REFERENCE (VCC or...
₹ 1,889.00 *
ADC3 click ADC3 click carries Microchip’s MCP3428 16-bit multichannel analog-to-digital converter. The click has four pairs of screw terminals onboard, letting you access the chip’s four differential input channels. At the highest resolution of...
₹ 2,309.00 *
Comparator click Comparator Click, carrying the LM2903 IC, has two independent precision voltage comparators. Two pairs of screw terminals allow you to connect separate inputs (additional two screw terminals are for GND connections). You can use it...
₹ 1,259.00 *
ADC2 click ADC 2 click carries MCP3551/3 , which is a 22-bit ADC with automatic internal offset and gain calibration. This high precision analog-to-digital converter has total unadjusted error of less than 10 ppm, and low-output noise of 2.5 µV...
₹ 2,519.00 *
DAC Click DAC Click is an accessory board in mikroBUS form factor. It includes a 12-bit Digital-to-Analog Converter MCP4921 that features an optional 2x buffered output and SPI interface. The board provides high accuracy and low noise performance...
₹ 1,889.00 *
DIGI POT click DIGIPOT Click is an accessory board in mikroBUS form factor. It features a single-channel digital potentiometer MCP4161 with 8-bit resolution (256 wiper steps) and industry-standard SPI serial interface. The resistance value of the...
₹ 1,779.00 *
DIGI POT 2 ADC3 click Analog Key MUX 3 Click EEG click ADC 8 Click ADC 6 click Voltmeter click ADC 5 click POT 3 Click DIGI POT click POT 2 Click DIGI POT 3 Slider 2 Click DIGI POT 4 ADC 7 click C Meter click Hz to V click PAC1934 click DigiVref Click POT Click LEM click DAC 5 Click PWR Meter 2 Waveform Click L meter click PIXI click ADC 4 click LED Driver 4 DAC 4 Click AC Current DAC 3 Click PWR Meter click DAC Click V to Hz 2 click ADAC click DIGI POT 5 Multimeter PAC1921 click MUX click ADC click Comparator MUX 2 click RMS to DC click ADC2 click V to Hz click
Viewed