Top seller
No results were found for the filter!
GNSS click GNSS click carries Quectel’s L86 GNSS module with a patch antenna along with an external antenna connector. GNSS stands for Global Navigation Satellite System, an umbrella term that describes both the United States GPS and the Russian...
₹ 6,849.00 *
GSM3 click With GSM3 click you can have two of the most used wireless communication protocols in one device — GSM/GPRS and Bluetooth. The click has an onboard 2.4 GHz active antenna, so it is Bluetooth compatible. It carries the SIM800H quad-band...
₹ 5,989.00 *
BLE2 click BLE2 click is an excellent choice if you want simple, temporary connectivity with your smart devices over Bluetooth 4.1. BLE2 click features the RN4020 module from Microchip, that integrates RF, a baseband controller, and a command API...
₹ 3,149.00 *
WiFi2 click WiFi2 click features the HLK-M30 WiFi module with a built-in TCP/IP protocol stack. The click is designed to run on a 3.3V power supply; it communicates with the target MCU over an UART interface and the following mikroBUS™ pins: AN,...
₹ 3,049.00 *
NFC Tag click NFC Tag click carries an M24SR64 NFC/RFID tag IC with a dual interface and 8KB of high-reliability EEPROM built-in. The RF protocol is compatible with both NFC Forum Type 4 Tag and ISO/IEC 14443 Type A. There’s three ways to operate NFC...
₹ 1,739.00 *
ccRF2 click ccRF2 click carries CC1120 , the fully integrated, high-performance single-chip radio transceiver with extremely low power consumption. Designed mainly for the ISM (Industrial, Scientific, and Medical) and SRD (Short Range Device)...
₹ 3,779.00 *
GPS3 click GPS3 click carries Quectel’s L80 GPS module, a high-sensitivity ultra slim GPS module with a patch antenna. The module incorporates several technologies that enhance the GPS performance. EASY™ Technology ensures that L80 can calculate...
₹ 4,619.00 *
BLE P click BLE P click carries the nRF8001 IC that allows you to add Bluetooth 4.0 to your device. The click communicates with the target board MCU through mikroBUS™ SPI (CS, SCK, MISO, MOSI), RDY and ACT lines, and runs on 3.3V power supply....
₹ 2,429.00 *
tRF click tRF click is an add-on board in mikroBUS form factor. It can be used to wirelessly send and receive UART data. It features the Telit LE70-868 - 868 MHz transceiver module with an embedded stack that is easy to integrate and use in...
₹ 6,199.00 *
ccRF click ccRF click is a low-power 2.4 GHz transceiver designed for the 2400- 2483.5 MHz ISM and SRD frequency bands. It features CC2500 Low-Power 2.4 GHz RF transceiver as well as PCB trace antenna. The CC2500 is integrated with a highly...
₹ 3,239.00 *
IR click IR Click is an add-on board in mikroBUS form factor. It’s a compact and easy solution for adding infrared (IR) remote control module to your design. It features TSOP38338 IR receiver module as well as QEE113 IR emitting diode. The 38 kHz...
₹ 1,369.00 *
GSM2 click GSM2 click is the simplest way to add GSM/GPRS communication layer to your project, for fast transmission of data, voice, and SMS. It features the Quectel quad-band M95 FA GSM/GPRS module that has an integrated TCP/IP protocol stack,...
₹ 4,619.00 *
I2C 1-Wire RS485 4 Click EERAM 3.3V DigiVref Click Ambient 3 Click RS232 2 click 1-Wire I2C MCP25625 click GNSS 7 click MCP2518FD click GSM3 click Air quality 3 ATA663211 click Gyro 2 Click L meter click MAC Address Opto 3 click FLICKER click USB UART click CAN Isolator RS485 3 click Buck 10 Click 6DOF IMU 4 DALI 2 click Air quality Temp Hum 9 Accel 7 click NFC Tag 2 click BroadR-Reach LLC SPI Click LED Flash click 6DOF IMU 11 LLC-I2C Click RS232 Isolator I2C Isolator 2 Matrix RGB RadioStation PWM 2 click Silent Step RS485 click 5V FRAM 2 click H-Bridge 2 IR Sense 3 UART 1-Wire Riverdi Display Heart Rate 7
Viewed