Top seller
No results were found for the filter!
Pmod CMPS2: 3-Axis Compass The Digilent Pmod CMPS2 is a digital compass module using Memsic's MMC34160PJ magnetometer. The local magnetic field strength can be measured in a ±16 Gauss range with a heading accuracy of 1° and up to 0.5 mG of resolution. Features:...
₹ 849.00 *
6" Pmod Cable Kit: 6-pin This kit is a handy accompaniment to your 6-pin Pmod. The extension cable lets you locate your Pmod away from its host board, and the included male gender changer can provide extra connectivity to both system and prototyping boards....
₹ 449.00 *
Pmod NIC100: Network Interface Controller The Pmod NIC100 is designed to provide a complete Ethernet interface featuring the Microchip ® ENC424J600 Stand-Alone Ethernet Controller. The ENC424J600 provides integrated MAC and PHY support, so Ethernet functionality can be added to...
₹ 2,349.00 *
Pmod VGA: Video Graphics Array The Pmod VGA provides a VGA port to any board with Pmod connectivity. The VGA port can be used to drive standard displays such as televisions and monitors. The host board must be capable of driving a fast parallel data bus in order to...
₹ 1,379.00 *
Pmod NAV: 9-axis IMU Plus Barometer The Digilent Pmod NAV uses the LSM9DS1 3-axis accelerometer, 3-axis gyroscope, 3-axis magnetometer, plus the LPS25HB digital barometer to provide users with 10-DOF functionality. The Pmod NAV provides a variety of orientation related...
₹ 3,849.00 *
Pmod AMP3: Stereo Power Amplifier The Pmod AMP3 uses a 2W Class-D audio power amplifier, the Analog Devices SSM2518 . Users are able to provide stereo audio through either I 2 S or TDM at a variety of sampling frequencies. The I 2 C interface can be used to configure the...
₹ 1,919.00 *
Pmod PMON1: Power Monitor The Pmod PMON1 is a power monitoring system that uses the Analog Devices AD5112 and ADM119 . By using I 2 C, users can set a reference voltage on the AD5112 to indicate what qualifies as an overcurrent condition for the ADM119. Once an...
₹ 959.00 *
Pmod IOXP: I/O Expansion Module The Pmod IOXP is an I/O expansion module powered by the Analog Devices ADP5589. By communicating with the chip through I 2 C, users can take advantage of up to 19 additional I/O pins as well as a keypad matrix decoder. Features:...
₹ 2,129.00 *
Pmod USBUART: USB to UART Interface The Pmod USBUART provides a USB to UART cross-conversion through the FTDI FT232R . Users may send data in either direction on the Pmod and receive the converted data in the appropriate format. Note: There are two UART signal pin...
₹ 1,439.00 *
Pmod RF2: IEEE 802.15 RF Transceiver The Pmod RF2 adds RF communication through the Microchip ® MRF24J40 IEEE 802.15.4™ 2.4GHz RF transceiver module. By communicating with the device through SPI, users can transmit data at speeds up to 625 kbps through the ZigBee ® , MiWi™,...
₹ 1,639.00 *
Pmod TPH2: 12-pin Test Point Header The Pmod TPH2 offers 12 external pin headers so that users can easily test the GPIO signals passing through each of the pins. Features: 12 external test point headers Easily access and test signals passing through Small PCB size for...
₹ 559.00 *
Pmod OD1: Open Drain Output The Pmod OD1 is an open drain FET module using NTHD4508 transistors. Users can then drive high current devices (up to 4.1A) by providing digital logic signals from the host board. Features: Two dual power N-FETs Comfortable drives 3.0 A...
₹ 769.00 *
SMA to Pmod ACL 3-axis Pmod DIP DIP to Pmod ENC Rotary Pmod HB5 Pmod MicroSD Pmod CMPS2 18 Pmod Cable Pmod NIC100 Pmod PMON1 Pmod DA3 One Pmod SF3 32 MB Pmod AMP3 Pmod LS1 Pmod OLED 128 x Pmod HAT Pmod BT2 Pmod Adapter Pmod ACL2 Pmod MIC3 MEMS Pmod Female Pmod RS485 Pmod DHB1 Dual Pmod TPH 6-pin Pmod GYRO 2x6-pin to Dual Pmod NAV 9-axis Pmod RJ45 RJ45 Pmod TPH2 Pmod OD1 Open Pmod VGA Video Pmod SSD Pmod AD5 Pmod CON3 R C Pmod DA4 Eight Pmod AMP2 Audio UART Crossover Pmod RF2 IEEE Pmod 8LD Eight Pmod TC1 K-Type Pmod BB Wire Pmod CLS Pmod AQS Pmod KYPD Digilent PCB Pmod RS232
Viewed