T he Digilent Pmod PIR is a Passive Infrared Sensor for monitoring movement at low power. With the EKMC1601111 , you can detect movement up to 5 meters away. Features: Optimized low-power modes High sensitivity center for small movements...

The Pmod ToF (Time of Flight) is a sensor that enables optical distance sensing at low power. The on-chip digital signal processor on the ISL29501 calculates the time it takes for light emitted by the ToF to travel to the target and...

The Pmod CLS is a character LCD module driven by the Atmel ATmega48 microcontroller. With a display size of 16x2 characters, users may display any information on the screen by communicating via SPI, I 2 C, or UART. Note: There are two...

The Pmod MicroSD provides a microSD card slot to any board that has 3.3V logic and is pin compatible with a 12-pin Pmod port capable of SPI communication. It allows the host board to read and write to the microSD card over a SPI...

The Digilent Pmod I2S2 features a Cirrus CS5343 Multi-Bit Audio A/D Converter and a Cirrus CS4344 Stereo D/A Converter, each connected to 3.5mm Audio Jacks. These circuits allow a system board to transmit and receive stereo audio signals...

The Pmod ESP32 provides an easy and cost effective way to add wireless communication to any host platform or project. It uses the fully certified ESP-WROOM-32 Wi-Fi + BLE + BT module from Espressif Systems. It is suitable for a wide...

The Digilent Pmod BLE is a powerful peripheral module meant for use with any UART enabled development board. This Pmod employs the Roving Networks RN4870 to create a fully integrated Bluetooth Low Energy interface. This chip features an...

The Digilent Pmod AQS is a digital gas sensor for monitoring indoor air quality at low power. With the AMS CCS811 , you can detect a wide range of Volatile Organic Compounds (VOCs) using the micro-hotplate technology, enabling a highly...

This kit is a handy accompaniment to your 12-pin Pmod. The extension cables let you locate your Pmod 6" away from its host board, or use your 12-pin Pmod on a system board with only two 6-pin Pmod headers available. We've also included...

The Digilent Pmod TC1 is a cold-junction thermocouple-to-digital converter module designed for a classic K-Type thermocouple wire. With Maxim Integrated's MAX31855, this module reports the measured temperature in 14-bits with 0.25°C...

The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A . Users may configure the output through I 2 C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature...

The Pmod SSD is a two-digit seven-segment display. Users can toggle through GPIO signals which digit is currently on at a rate of 50 Hz or greater to achieve persistence-of-vision to give the effect of both digits being lit up...