F1031V Mass Air Flow Sensor adopts thermodynamic principle to detect flow rate of gas medium in the flow channel, with high precision and good repeatability. It comes with built-in temperature sensor to provide temperature compensation...

Ever want to build your own weather station? This anemometer is made of shell, wind cups and circuit module. It has built-in photovoltaic module, industrial microcomputer processor, and standard current generator. Made with aluminium...

This is an Arduino Carbon Monoxide Sensor. It uses MQ7 probe to detect Carbon Monoxide (CO) concentrations in the air from 20 to 2000ppm. The sensitivity can be adjusted by the potentiometer. The output is proportional to the density of...

The LoCoBot is an ROS research rover for mapping, navigation and manipulation (optional) that enables researchers, educators and students alike to focus on high level code development instead of hardware and building out lower level...

This rugged, 4-wheel-drive chassis from Dagu Electronics is a smaller version of the Wild Thumper 6WD chassis . It is designed to excel at traversing rough terrain, making it a great platform for any robot that needs to perform tasks in...

Based on a new generation ARM Cortex M7, the Qwiic Tsunami Super WAV Trigger extends polyphony to 32 mono or 18 stereo simultaneous uncompressed 44.1kHz, 16-bit tracks. Each track can start, pause, resume, loop and stop independently,...

This is a waterproofed version of the DS18B20 Temperature sensor . Handy for when you need to measure something far away, or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC so we suggest keeping it...

This product is intended to be used together with the Crazyflie 2.X expansion deck system. Package contents 4 x short male expansion pin-header (top 9mm long) 4 x medium male expansion pin-header (top 15mm long) Resources Datasheet

Spare Crazyflie 2.X brushed coreless DC-motor. Mechanical specifications: Diameter: 7.0 mm Length: 16.0 mm Shaft length: 3.5 mm Shaft diameter: 0.8 mm Weight: 2.7 g Wire length: 32.0 mm Molex Picoblade 2P connector Electrical...

Spare battery holder deck for Crazyflie 2.X. Mechanical specifications: Weight: 0.4g Size (WxHxD): 28x28x4mm Package contents: 1 x Battery holder deck Ressources: Datasheet

Use the Bitcraze battery charger to always have your spare batteries full to maximize your flight time. If you’re a bit handy with a soldering iron you can even solder multiple chargers together for multi-battery charging. For more...

Make sure to get the maximum amount of flight-time from your Crazyflie 2.X using this spare battery. Features: Operating Temperature: 0~45°C (Charging) / 0~60°C (Discharging) Connector: Molex 51005-2P (Pin 1 positive) Package Contents: 1...