This is a 4 port USB hub for Raspberry Pi, provides more USB capability to your Pi, what's more, it features USB to UART converter for easy serial communication. It can work with various versions of the Pi, and the size of the board is...

200x200, 1.54inch E-Ink raw display, SPI interface, without PCB. This is an E-Ink raw display, 1.54inch, 200x200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like...

200x200, 1.54inch E-Ink display module, SPI interface. This is an E-Ink display module, 1.54inch, 200x200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra...

This is a general OLED display Module, 0.91inch diagonal, 128x32 pixels, with embedded controller, communicating via I2C interface. Features 0.91inch small form factor 128x32 high resolution I2C interface, requires only two signal pins...

1200x825, 9.7inch E-Ink raw display, parallel port, without PCB. This is an E-Ink raw display, 9.7inch, 1200x825 resolution, communicating via parallel port. Due to the advantages like ultra low power consumption, wide viewing angle,...

1200x825, 9.7inch E-Ink display HAT for Raspberry Pi, IT8951 controller, USB/SPI/I80/I2C interface. This is an E-Ink display HAT for Raspberry Pi, 9.7inch, 1200x825 resolution, with embedded controller IT8951, communicating via...

Features 1024×600 high resolution Resistive touch control Compatible and Direct-connect with any revision of Raspberry Pi (except the Pi 1 model B or Pi Zero, which requires an HDMI cable) Drivers provided (works with your own...

Key Parameters LCD Type TFT Interface RGB/LVDS Touch Controller FT5406 Touch Panel Type Capacitive (5 multi-touch) Backlight LED Display Size (mm) 222.72(W)×125.28(H) Dot Pitch (mm) 0.2175(W)×0.2088(H) Aspect Ratio 16 : 9 Resolution 1024...

10 DOF IMU Sensor (C), Inertial Measurement Unit, Lower Power Consumption. 10 DOF IMU Sensor (C) is good at motion monitor, as well as detecting/measuring the position, height, and temperature. It would be helpful for making your own...

This is a colorful display module designed for the BBC micro:bit, 1.8inch diagonal, 160x128 pixels, capable of displaying 65K colors. Tired of the 5x5 LED matrix? Time to get a tiny monitor for your micro:bit, this one would be the ideal...

This is the SparkFun MiniGen Signal Generator, a small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz, and approximately 1Vp-p. Though the MiniGen is technically a shield it...

The SparkFun 9DoF Razor IMU M0 combines a SAMD21 microprocessor with an MPU-9250 9DoF (9 Degrees of Freedom) sensor to create a tiny, reprogrammable, multipurpose IMU (Inertial Measurement Unit). It can be programmed to monitor and log...