Products from Holybro

These Pixhawk baseboards can be used with Pixhawk 6X, 5X, and any flight controller that follow the Pixhawk Bus Standard. Pixhawk Standard Baseboard v2A & V2B Ports can be found here Pixhawk Standard Baseboard v1 Ports Pinout can be...

This Power Distribution Board (PDB) is used for PM02, PM02D Power Module. Power modules with build-in power distribution such as the PM03, PM06, PM07 would not require this PDB. There are two options, with or without XT30 pre-soldered....

Feature: All new High-quality MOSFETs with low internal resistance & heat generation, and individual metal heatsink New and faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz) Separate drive & control circuit, reducing the...

The Holybro Kakute H7 Mini is a Flight Controller full of features, including onboard VTX ON/OFF Pit Switch with battery voltage, HD System/VTX & 4in1 ESC plugs, barometer, OSD, 6x UARTs, easy soldering layout, and much more. The Kakute...

Description PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a...

Key Design Points Redundancy: 3x ICM-45686 IMU sensors ( ±32g) with BalancedGyro™ technology & 2x Barometer sensors High-performance STM32H753 Processor with a clock speed of up to 480 MHz Modular flight controller: separated IMU, FMU,...

The Pixhawk® 6C is the latest update to the successful family of Pixhawk® flight controllers, based on the Pixhawk® FMUv6C Open Standard and Connector Standard. It comes with PX4 pre-installed. Inside the Pixhawk® 6C, you can find an...

These Pixhawk baseboards can be used with Pixhawk 6X, 5X, and any flight controller that follow the Pixhawk Bus Standard. Pixhawk Standard Baseboard v2A & V2B Ports can be found here Pixhawk Standard Baseboard v1 Ports Pinout can be...

This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal...

UBEC 12A (3-14S) is a synchronous step-down regulator from a high voltage or widely varying input supply. It draws the DC voltage from a 3-14S LiPo battery and drops the voltage to a level suitable for receivers and other electronic...

Tekko32 F4 45A ESC is the latest BLHeli32 ESC from HolyBro. The Tekko32 ESC runs in conjunction with an ARM 32bit compatible F4 MCU. It can run input signals with lower latency, at faster rates, smooths out the RPM band, is capable of...

This Power Distribution Board (PDB) is used for PM02, PM02D Power Module. Power modules with build-in power distribution such as the PM03, PM06, PM07 would not require this PDB. There are two options, with or without XT30 pre-soldered....