Top seller
No results were found for the filter!
WiFi2 click WiFi2 click features the HLK-M30 WiFi module with a built-in TCP/IP protocol stack. The click is designed to run on a 3.3V power supply; it communicates with the target MCU over an UART interface and the following mikroBUS™ pins: AN,...
₹ 3,049.00 *
NFC Tag click NFC Tag click carries an M24SR64 NFC/RFID tag IC with a dual interface and 8KB of high-reliability EEPROM built-in. The RF protocol is compatible with both NFC Forum Type 4 Tag and ISO/IEC 14443 Type A. There’s three ways to operate NFC...
₹ 1,739.00 *
ccRF2 click ccRF2 click carries CC1120 , the fully integrated, high-performance single-chip radio transceiver with extremely low power consumption. Designed mainly for the ISM (Industrial, Scientific, and Medical) and SRD (Short Range Device)...
₹ 3,779.00 *
GPS3 click GPS3 click carries Quectel’s L80 GPS module, a high-sensitivity ultra slim GPS module with a patch antenna. The module incorporates several technologies that enhance the GPS performance. EASY™ Technology ensures that L80 can calculate...
₹ 4,619.00 *
BLE P click BLE P click carries the nRF8001 IC that allows you to add Bluetooth 4.0 to your device. The click communicates with the target board MCU through mikroBUS™ SPI (CS, SCK, MISO, MOSI), RDY and ACT lines, and runs on 3.3V power supply....
₹ 2,429.00 *
tRF click tRF click is an add-on board in mikroBUS form factor. It can be used to wirelessly send and receive UART data. It features the Telit LE70-868 - 868 MHz transceiver module with an embedded stack that is easy to integrate and use in...
₹ 6,199.00 *
ccRF click ccRF click is a low-power 2.4 GHz transceiver designed for the 2400- 2483.5 MHz ISM and SRD frequency bands. It features CC2500 Low-Power 2.4 GHz RF transceiver as well as PCB trace antenna. The CC2500 is integrated with a highly...
₹ 3,239.00 *
IR click IR Click is an add-on board in mikroBUS form factor. It’s a compact and easy solution for adding infrared (IR) remote control module to your design. It features TSOP38338 IR receiver module as well as QEE113 IR emitting diode. The 38 kHz...
₹ 1,369.00 *
GSM2 click GSM2 click is the simplest way to add GSM/GPRS communication layer to your project, for fast transmission of data, voice, and SMS. It features the Quectel quad-band M95 FA GSM/GPRS module that has an integrated TCP/IP protocol stack,...
₹ 4,619.00 *
nRF T click nRF T Click is an add-on board in mikroBUS form factor. It features Nordic nRF24L01P 2.4 GHz transceiver module with an embedded baseband protocol engine as well as 2.4 GHz PCB trace antenna. The board supports an air data rate of 250...
₹ 2,369.00 *
nRF C click nRF C Click is an add-on board in mikroBUS form factor. It features Nordic nRF24L01P 2.4 GHz transceiver module with an embedded baseband protocol engine as well as 2.4 GHz SMD chip antenna. The board supports an air data rate of 250...
₹ 2,869.00 *
GSM Click Precision control GSM click is the easiest way to add GSM/GPRS communication to your device. The click features Telit's GL865-QUAD module. GSM click runs either on 3.3V or 5V power supply and communicates with the target microcontroller...
₹ 7,349.00 *
RFid click AnyNet 3G-EA IrDA2 click BT Audio click WiFi3 click 4G LTE-APJ Bluetooth click LoRa click 4G LTE-E click nRF T click BLE 4 Click NANO GPS click WiFly click SPIRIT click GPS Click GPS3 click tRF click GNSS 7 click NFC Tag 2 click SigFox 2 Click GNSS 5 click NFC Extend 3G SARA click RN4678 click GSM-GPS click NFC Tag click RN4870 click WiFi 9 Click NFC click MPU 9DOF Click CC3100 click LoRa 2 Click WiFi 4 click ccRF2 click ccRF click BLE 3 click nRF C click LoRa 3 click GNSS click MiWi 2 click WiFi ESP click GPS 4 click GSM GNSS click IQRF click MiWi click 4G LTE-NA click
Viewed