The chipKIT™ Starter Kit provides a wide range of sensors, actuators, and electronic components at a remarkably low cost, enabling the construction of an endless array of projects that can serve to inform beginners or empower experts....

Get your students quickly involved in building essential electronic circuits using myParts Kit supported by the Texas Instruments ® University Program. The set of key components in the myParts Kit encourages hands-on experimentation with...

The NI myRIO Starter Accessory Kit includes everything you need to get started connecting to and programming the I/O of NI myRIO. Kit Contents: Barrel connector with leads Assorted capacitors Diodes 7-segment display Mechanical rotary...

This sticker sheet provides 30 plastic labels for the 30 pins on the Analog Discovery 2 flywires. We've heard from our users that it can be tedious to find the correct wire out of the 30 color-coded flywires each time they need to be...

The Digilent Pmod DIP is a 12-pin dual in-line package (DIP) that also includes a 2×6 female Pmod header, allowing users to easily separate and process any signals traveling to and from their 12-pin Pmod. It allows for easy use of...

The Pmod DA1 is an 8-bit Digital-to-Analog Converter powered by two Analog Devices AD7303 . With simultaneous dual outputs per single input, users can perform up to four isolated tests on the analog outputs. Users may provide data to the...

The Pmod CON4 allows users to connect their system to two RCA audio jacks. GPIO signals can be transferred in either direction through the audio jacks with jumper blocks to adjust signal routing. Features: 2 RCA audio jacks Receive and...

The Pmod CON1 is a small module with six screw terminals to interface with external wires that are not compatible with the DIP standard. Two of the terminals can be used to provide power from an outside source and the other four can be...

The Digilent Pmod COLOR is a color sensor module with the ability to sense red, green, blue and clear light. The onboard AMS's TCS3472 integrates an IR blocking filter to accurately determine the color of objects as well as sense ambient...

Useful for securely attaching a Pmod to your project or application. Features: Works with any Pmod 0.80" in width Can also accomodate a Cerebot Nano What's Included: One Pmod clip One 8-32 nut, screw, and washer

The Pmod CAN is a CAN 2.0B controller with an integrated transceiver. The embedded Microchip MCP25625 chip connects directly to the physical CAN bus and meets automotive requirements for high-speed (1 Mb/s), low quiescent current,...

The Pmod BB provides a ready-made solution for prototyping breadboard circuits. With the 2x6 pin header you can directly apply your digital or analog signals without going through the hassle of extra jumper wires. Features: 266 tie point...