Start learning and experimenting with electronics with the Analog Discovery 2. The chipKIT starter kit provides an opportunity to start communicating with displays, digital logic ICs, motors, sensors, and analog circuits. With the...

This kit is a handy accompaniment to your 6-pin Pmod. The extension cable lets you locate your Pmod away from its host board, and the included male gender changer can provide extra connectivity to both system and prototyping boards....

The DMC 60 is a powerful and compact motor drive/amplifier designed for robotics, electric vehicles, or any application where easy bidirectional control of DC brushed motors is needed. The DMC 60 is controlled using a standard hobby...

The NI myRIO Embedded Kit contains common sensors, devices, and a display. Most of the products within the kit are also available for separate purchase. Kit contents: PmodBT2 (410-214): Bluetooth interface PmodCLS (410-092): LCD display,...

INTRODUCTION What is iBeacon? iBeacon is a protocol standardised by Apple and introduced at the Apple Worldwide Developers Conference in 2013. Various vendors have since made iBeacon-compatible hardware transmitters - typically called...

INTRODUCTION Sometimes battery information is not readily available or is hard to understand at a glance. Our Battery Capacity Indicator is a user friendly indicator interface that you can use in your projects. via GIPHY SPECIFICATION...

INTRODUCTION A relay is an electrically operated switch, which has a control system (also known as the input circuit) and the controlled system (also known as the output circuit), usually used in automatic control circuit. It is actually...

INTRODUCTION This is an Arduino-compatible TDS sensor/Meter Kit for measuring TDS value of the water, to reflect the cleanliness of the water. It can be applied to domestic water, hydroponic and other fields of water quality testing. TDS...

INTRODUCTION It's time to get Bluetooth 4.0 into your project and sync it up with your phone! For aficionados of smart devices and wearables with this new tech (BT4.0 BLE), now you can go further than hacking things apart to start...

INTRODUCTION The BMI160 6-axis inertial motion sensor is a new product from DFRobot. It is based on Bosch BMI160 6-axis MEMS sensor which integrates 16-bit 3-axis accelerometer with ultra-low-power 3-axis gyroscope. Bosch BMI160 is...

DFRobot Gravity: analog electrical conductivity sensor/meter(K=10) is particularly used to measure the high electrical conductivity liquid, such as seawater, concentrated brine, etc. The measurement range is up to 100ms/cm. This product...

The Digilent Cmod A7 is a small, breadboard friendly 48-pin DIP form factor board built around a Xilinx Artix-7 FPGA. The board also includes a USB-JTAG programming circuit, USB-UART bridge, clock source, Pmod host connector, SRAM,...