Rugged motor/gearbox set suitable for use with Digilent Robotic Starter Kit, separate parts of the RSK or custom applications. Ships with 2mm screws for attachment to our motor mounts. Features: Motor/gearbox with rugged, heavy duty...

Rugged metal motor mounts suitable for use with the Robotic Starter Kit (RSK), Base Plate Expansion or custom applications. Note: This kit does not include motors! Features: 5 3/8" wide for use with the Robotic Starter Kit (RSK or Base...

An SMA to Alligator Clip Cable for a clean signal connection. Do you find yourself wishing that your signals were crisp, clean, and unimpeded unlike what you receive out of breadboard wires? Or perhaps do you find yourself called to a...

Features: 6", 6-pin crossover cable Connects newer UART-interface Pmods (PmodBT) to older microcontroller boards (Cerebot 2, Cerebot 32MX4, etc.) Connects older UART-interface Pmods (PmodCLS, PmodRS232, etc.) to newer microcontroller...

Start building a wide variety of useful circuits and devices from the large selection of parts and components included in the Analog Parts Kit. With the Analog Discovery 2 USB oscilloscope, you'll be able to measure, visualize, generate,...

The 2x6 Digital Discovery signal cable assembly, or flywire, is the same assembly that ships with every Digital Discovery we sell. The 2X6 flywire features two VCCIO_USR wires (red), two GND wires (black), and eight signal wires...

The 2x16 Digital Discovery signal cable assembly, or flywire, is the same assembly that ships with every Digital Discovery we sell. This assembly features a 2x16 keyed female pin connector for the DIN_USR connector, with 24 DIN signals...

The High Speed Logic Probes come in a pack of four twisted cables. Each cable has a GND (black) wire twisted to a DIN_USR (colored) wire. The wire connects to the High Speed Adapter via a 2-pin female header, and two 1-pin female...

This accessory kit includes everything you need to get started with the PYNQ-Z1 board! Products can also be purchased individually. What's Included: Micro USB cable Ethernet cable microSD card pre-loaded with PYNQ-Z1 boot image 12V, 3A...

Clear, sleek covers made out of plexiglass specifically designed to protect your PYNQ-Z1 . The covers are easily attached to the PYNQ-Z1 using the four included stand-offs along with eight screws, protecting the top and bottom of the...

The Zybo Pmod Pack was designed to complement features of the Zybo Zynq-7000 FPGA, allowing users to expand project possibilities by utilizing a variety of peripheral modules! The Zybo Pmod Pack includes the Pmod BT2, Pmod ALS, Pmod...

Features: Angled headers for Pmod and breadboard connectivity Changes a 6-pin female header to a male header Provides easy access for test and measurement Ships in a pack of 5