Besides the protection features that include short-circuiting protection and thermal overload protection, this Click board™ features a few more options that ensure flawless operation of this amplifier Click board™. Features such as the...

In addition to the possibility to attenuate the input signal from the included 3.5mm JACK connector, AudioAMP 4 click can use analog voltage as the amplifier input, derived from the PWM signal at the mikroBUS™ PWM pin. This allows the...

Featuring a set of 3.5mm vertical jack connectors onboard, it allows a simple connection to an existing audio chain. Because of its very good sound characteristics, including 0.01% of total harmonic distortion (THD), signal to noise...

Equipped with six digitally controlled attenuators, featuring high channel separation, extremely low noise, great SNR ratio of more than 100dB, and low count of required external components. How Does It Work? The main component of the...

Offering the complete message playback and recording platform that offloads heavy compression calculations from the host MCU, Rec&Play click allows rapid development of a wide range of sound-based applications, greatly cutting the time...

This Click board™ requires an external Power Supply Unit (PSU) for its operation. It can use a wide range of power supply voltages, from 3.5V up to 14.4V. Audio Amp 5 click a perfect solution for different kinds of active desktop...

The small omnidirectional electret microphone features a reasonably flat frequency response, and it can be used within the frequency range between 100 Hz and 20 kHz. This range is perfectly suited for audio and/or speech applications....

This Click board™ is configured to drive a single speaker, using its outputs tied in parallel. It requires an external Power Supply Unit (PSU) for its operation. It can use a wide range of power supply voltages, from 3.5V up to 14.4V....

Riverdi click is an adapter for connecting Riverdi TFT displays to a mikroBUS socket. The onboard zif20 connector allows you to interface between the target MCU and an FT8xx graphic controller on Riverdi displays. The click runs on...

eINK click is an adapter for connecting eINK displays, with a 24pin ribbon cable. The eINK display sold with the click can retain the image even when the power is off. The click board™ is designed to run on a 3.3V power supply. It...

Skywire™ click is an adapter click, which hosts NimbeLink/Skywire™ cellular modems (using stacking headers) to MikroElektronika development boards . It carries the MCP1826 low dropout regulator from Microchip. Skywire™ click is designed...

Adapter Click™ is a breakout board which simplifies connection of add-on boards with IDC10 headers to mikroBUS™ socket. There are two ways of establishing connection: using male or female IDC10 connectors. Both are provided with the...