RF Meter click is a radio frequency power measurement device covering a frequency span from 1 MHz to 8 GHz over a 60 dB range (approximately). It enables monitoring and measuring frequency levels to ensure proper functioning and leak...

DALI is an international standardized protocol for intelligent digital lighting control, that enables an easy implementation of robust, scalable and flexible lighting networks. DALI stands for Digital Addressable Lighting Interface and...

Glucometer is a medical device for determining the approximate concentration of glucose in the blood. A small drop of blood, obtained by pricking the skin with a lancet, is placed on a disposable test strip that the meter reads and uses...

10DOF click is a mikroBUS add-on board for enhancing hardware prototypes with 10DOF functionality (10 degrees of freedom). The click board carries two modules from Bosch: BNO055 , a 9-axis absolute orientation sensor and BMP180 , a...

Heart rate 4 click carries the MAX30101 high-sensitivity pulse oximeter and heart-rate sensor from Maxim Integrated. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target MCU over I2C interface,...

LoRa click carries Microchip’s RN2483 fully certified LoRa Sub-GHz, 433/868 MHz European R&TTE Directive Assessed Radio Modem. The click is designed to use either a 3.3V or a 5V power supply. It communicates with the target...

Stretch click is a mikroBUS™ add-on board with circuitry for measuring stretch forces with conductive rubber cords. The click has screw terminals for connecting 2mm-diameter conductive rubber cord. The resistance of the cord increases...

MySignals is a development platform for medical devices and eHealth applications. You can use MySignals to develop your eHealth web or even to add your own sensors to build new medical devices. The MySignals SW Complete Kit includes...

Ozone 2 click carries an MQ131 sensor for Ozone (O 3 ). The sensor outputs an analog voltage, which is converted by the onboard MCP3551 22-bit ADC converter or it is sent to the microcontroller via AN pin on the mikroBUS™, depending on...

USB I2C click carries an MCP2221 USB-to-UART/I2C converter. The chip supports full-speed USB (12 Mb/s), I2C with up to 400 kHz clock rates and UART baud rates between 300 and 115200. The board communicates with the target MCU through...

This product has been discontinued by manufacturer. MySignals is a development platform for medical devices and eHealth applications. You can use MySignals to develop your eHealth web or even to add your own sensors to build new medical...

This product has been discontinued by manufacturer. MySignals is a development platform for medical devices and eHealth applications. You can use MySignals to develop your eHealth web or even to add your own sensors to build new medical...