10DOF click is a mikroBUS add-on board for enhancing hardware prototypes with 10DOF functionality (10 degrees of freedom). The click board carries two modules from Bosch: BNO055 , a 9-axis absolute orientation sensor and BMP180 , a...

Heart rate 4 click carries the MAX30101 high-sensitivity pulse oximeter and heart-rate sensor from Maxim Integrated. The click is designed to run on either 3.3V or 5V power supply. It communicates with the target MCU over I2C interface,...

LoRa click carries Microchip’s RN2483 fully certified LoRa Sub-GHz, 433/868 MHz European R&TTE Directive Assessed Radio Modem. The click is designed to use either a 3.3V or a 5V power supply. It communicates with the target...

Stretch click is a mikroBUS™ add-on board with circuitry for measuring stretch forces with conductive rubber cords. The click has screw terminals for connecting 2mm-diameter conductive rubber cord. The resistance of the cord increases...

MySignals is a development platform for medical devices and eHealth applications. You can use MySignals to develop your eHealth web or even to add your own sensors to build new medical devices. The MySignals SW Complete Kit includes...

Ozone 2 click carries an MQ131 sensor for Ozone (O 3 ). The sensor outputs an analog voltage, which is converted by the onboard MCP3551 22-bit ADC converter or it is sent to the microcontroller via AN pin on the mikroBUS™, depending on...

USB I2C click carries an MCP2221 USB-to-UART/I2C converter. The chip supports full-speed USB (12 Mb/s), I2C with up to 400 kHz clock rates and UART baud rates between 300 and 115200. The board communicates with the target MCU through...

This product has been discontinued by manufacturer. MySignals is a development platform for medical devices and eHealth applications. You can use MySignals to develop your eHealth web or even to add your own sensors to build new medical...

This product has been discontinued by manufacturer. MySignals is a development platform for medical devices and eHealth applications. You can use MySignals to develop your eHealth web or even to add your own sensors to build new medical...

Compass 2 click carries the AK8963 3-axis electronic compass. The AK8963 sensor is based on the Hall effect. The click is designed to run on a 3.3V power supply only. It communicates with the target microcontroller through either I2C or...

The design of the board is based on an OpAmp set up as a differential amplifier with a buffered input. Two onboard screw terminals (probe+ and probe-) are bringing in the current, which then flows through a row of four resistors. A...

The electrocardiogram (ECG) is a diagnostic tool that is routinely used to assess the electrical and muscular functions of the heart. The sensor use “Continuous telemetry electrocardiogram" for a prolonged monitoring including the...