Products from Digilent

Note: purchase the bundle of all four PowerBRICKs and save! Every circuit needs a power supply, but simple, low cost, portable, and reliable power sources can be hard to come by. The PowerBRICK family provides the solution to all of...

Note: purchase the bundle of all four PowerBRICKs and save! Every circuit needs a power supply, but simple, low cost, portable, and reliable power sources can be hard to come by. The PowerBRICK family provides the solution to all of...

Note: purchase the bundle of all four PowerBRICKs and save! Every circuit needs a power supply, but simple, low cost, portable, and reliable power sources can be hard to come by. The PowerBRICK family provides the solution to all of...

The Digilent Cmod S6 is a small, 48-pin DIP form factor board built around a Xilinx ® Spartan ® -6 LX4 FPGA. The board also includes a programming ROM, clock source, USB programming and data transfer circuit, power supplies, and basic...

The Pmod AMP3 uses a 2W Class-D audio power amplifier, the Analog Devices SSM2518 . Users are able to provide stereo audio through either I 2 S or TDM at a variety of sampling frequencies. The I 2 C interface can be used to configure the...

The Pmod PMON1 is a power monitoring system that uses the Analog Devices AD5112 and ADM119 . By using I 2 C, users can set a reference voltage on the AD5112 to indicate what qualifies as an overcurrent condition for the ADM119. Once an...

The Pmod Shield is an adapter board from the Uno R3 style shield headers present on many Digilent system boards to Pmod. It provides the additional circuitry and connectors necessary to allow Digilent Pmods to be plugged directly in...

The Pmod IOXP is an I/O expansion module powered by the Analog Devices ADP5589. By communicating with the chip through I 2 C, users can take advantage of up to 19 additional I/O pins as well as a keypad matrix decoder. Features:...

The Pmod USBUART provides a USB to UART cross-conversion through the FTDI FT232R . Users may send data in either direction on the Pmod and receive the converted data in the appropriate format. Note: There are two UART signal pin...

The Pmod RF2 adds RF communication through the Microchip ® MRF24J40 IEEE 802.15.4™ 2.4GHz RF transceiver module. By communicating with the device through SPI, users can transmit data at speeds up to 625 kbps through the ZigBee ® , MiWi™,...

The Pmod TPH2 offers 12 external pin headers so that users can easily test the GPIO signals passing through each of the pins. Features: 12 external test point headers Easily access and test signals passing through Small PCB size for...

The Pmod OD1 is an open drain FET module using NTHD4508 transistors. Users can then drive high current devices (up to 4.1A) by providing digital logic signals from the host board. Features: Two dual power N-FETs Comfortable drives 3.0 A...