Products from MikroElektronika

8x8 G Click is an add-on board in mikroBUS™ form factor. It’s a compact and easy solution for adding 8x8 GREEN LED display matrix to your design. It features MAX7219 8-digit LED display driver module as well as 64 GREEN LED diodes. 8x8 G...

8x8 Y Click is an add-on board in mikroBUS form factor. It’s a compact and easy solution for adding 8x8 YELLOW LED display matrix to your design. It features MAX7219 8-digit LED display driver module as well as 64 YELLOW LED diodes. 8x8...

8x8 R Click is an add-on board in mikroBUS form factor. It’s a compact and easy solution for adding 8x8 RED LED display matrix to your design. It features MAX7219 8-digit LED display driver module as well as 64 RED LED diodes. 8x8 R...

7seg click is an accessory board in mikroBUS form factor. It’s a compact and easy solution for adding 2-digit seven-segment display to your device. It features two 74HC595 8-bit serial-in, parallel-out shift register modules as well as...

7-segment LED display is the most commonly used type of display to represent changing numerical values. The principle is very simple - seven LED segments are positioned in a certain shape and by turning specific segments on or off, the...

How does it work? When it comes to driving an array of LED segments, using so-called shift-register ICs is almost unavoidable. This Click board™ uses a single 74HC595 IC , a tri-state, serial-in, parallel-out, 8-bit shift-register with...

RGB Driver click is an RGB LED driver, capable of driving RGB LED stripes, LED fixtures and other RGB LED applications that demand an increased amount of current and voltage. Besides the NCP5623B IC, a triple output RGB LED driver IC,...

TouchClamp click is a mikroBUS™ add-on board with NXP’s MPR121 proximity capacitive touch sensor controller. It has seven plated holes for clamps which can be used to connect any – literally any – conductive object in order to use it as...

IR Gesture click is a mikroBUS add-on board that enables contactless gesture recognition, along with ambient light and proximity sensing capabilities with the APDS-9960 IC. This sensor integrates an LED and four directional photodiodes...

Button G click is the simplest solution for adding a single pushbutton to your design. The button itself is transparent, 6.8mm in diameter and has a green LED backlight. When pressed, it sends an interrupt signal to the target board...

Touchpad click is a capacitive touch input device driven by Microchip’s low-powered MTCH6102 controller. The touchpad surface is covered with a sheet of black plastic to demonstrate the chip’s support for cover layers (up to 3mm for...

Counter click carries an LS7366R 32-bit quadrature counter. The top of the board has a pinout for interfacing with incremental encoders. The interface has ENCA and ENCB pins, along with ENCI, which is a programmable index. The A and B...