INTRODUCTION This new released BMP388 barometric pressure sensor by DFRobot is equipped with the functionality of temperature and pressure measurement. It supports Arduino code control. Compared with the earlier version of BMP180, BMP280...

INTRODUCTION OBD II is an On-Board Diagnostics standard that is used on a large variety of cars. It provides access to numerous data from the engine control unit (ECU) and offers a valuable source of information when troubleshooting...

The Pmod PS/2 is a module that allows users to interface PS/2 style mice or keyboards with their system. By supplying a clock signal to the Pmod, users can then receive the standard 11-bit words that are sent from the attached...

This kit is a handy accompaniment to your 6-pin Pmod. The extension cable lets you locate your Pmod away from its host board, and the included male gender changer can provide extra connectivity to both system and prototyping boards....

The Discovery BNC adapter board is intended to be used with the Analog Discovery™ tool to enable the use of standard BNC-terminated test leads and probes. It provides BNC terminations to each of the two oscilloscope channels on the...

The Pmod CON3 can be easily used to interface with up to four small servo motors that deliver anywhere from 50 to 300 ounce/inches of torque, such as those used in radio controlled airplanes or cars, as well as some mechatronics...

The Arty Z7 is a ready-to-use development platform designed around the Zynq-7000™ All Programmable System-on-Chip (AP SoC) from Xilinx. The Zynq-7000 architecture tightly integrates a dual-core, 650 MHz ARM Cortex-A9 processor with...

INTRODUCTION Gravity: Lightning Sensor employs AMS innovative AS3935 Franklin lightning sensor IC and Coilcraft MA5532-AE dedicated antenna to detect lightning distance, intensity, and frequency within a radius of 40km both indoors or...

The JTAG-HS3 is the newest member of our family of affordable high-speed Xilinx ® FPGA programming solutions. The HS3 builds on the successful JTAG-HS1 by adding an open-drain buffer to pin 14 allowing for the debugging of Xilinx...

The Pmod DA4 is an 8 channel 12-bit Digital-to-Analog Converter run via the Analog Devices AD5628 . By communicating with the device through SPI, users may send different analog values on individual channels or output to all 8 channels...

INTRODUCTION The DFRobot Vibration Sensor buffers a piezoelectric transducer that responds to strain changes by generating a measurable output voltage change which is proportional with the strength of vibration. So you can know the...

INTRODUCTION Are you tired with clicking mechanic button? Try our capacitive touch sensor. Right now we can find touch sensor on most electronic device. So uprade your Arduino project with our new version touch sensor and make it cool!!...