The Pmod TMP3 is an ambient temperature sensor built around the Microchip TCN75A . Users may configure the output through I 2 C to up to 12 bits of resolution as well as setting a trigger to occur when a user defined temperature...

The Pmod SSD is a two-digit seven-segment display. Users can toggle through GPIO signals which digit is currently on at a rate of 50 Hz or greater to achieve persistence-of-vision to give the effect of both digits being lit up...

The Pmod RTCC is a real-time clock/calendar powered by the Microchip ® MCP79410. Through the I 2 C interface, users may configure up to two alarms that can be triggered at a wide variety of possible times. Note: The Pmod RTCC is also...

The Pmod R2R is resistor ladder with a R-2R resistor configuration. Users can provide 8-bits of parallel data to the module through GPIO signals. This setup teaches users the basic principles behind a Digital-to-Analog Converter....

The Pmod PS/2 is a module that allows users to interface PS/2 style mice or keyboards with their system. By supplying a clock signal to the Pmod, users can then receive the standard 11-bit words that are sent from the attached...

The Pmod OLED is 128x32 pixel monochrome organic LED (OLED) panel powered by the Solomon Systech SSD1306. Users can display any sort of graphical design by programming the device through SPI as well as sending bitmap images. This module...

The Pmod MAXSONAR is a single-transducer ultrasonic range finder that uses the MaxBotix ® LV-MaxSonar ® -EZ1™ . Users can measure how far away an object is with an accuracy within 1 inch to over 20 feet away. Information is sent in a...

The Digilent Pmod LS1 allows users to receive signals from multiple optical sensors, such as the popular combination of an IR LED with an IR sensor used in line-following robots. Features: Infrared light detector with on-board...

The Pmod KYPD is a 16-button keypad arranged in a hexidecimal format (0-F). By digitally driving a column line to a logic low level and digitally reading each of the rows, users can determine which button is currently pressed. Features:...

The Pmod GYRO is a 3-axis gyroscope powered by the STMicroelectronics L3G4200D . By communicating with the chip through SPI or I 2 C, users may configure the module to report angular momentum at a resolution of up to 2000 dps at an...

The Pmod ENC features a rotary shaft encoder with an integral push-button to provide multiple types of outputs such as a way for users to quickly switch between multiple choices shown on a screen or predefined motor speeds. The module...

The Pmod DHB1 uses the Texas Instruments ® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals. Features: Dual H-Bridge capable of 1.5A RMS Two quadrature...