The design of the board is based on an OpAmp set up as a differential amplifier with a buffered input. Two onboard screw terminals (probe+ and probe-) are bringing in the current, which then flows through a row of four resistors. A...

The electrocardiogram (ECG) is a diagnostic tool that is routinely used to assess the electrical and muscular functions of the heart. The sensor use “Continuous telemetry electrocardiogram" for a prolonged monitoring including the...

This sensor allows you to measure this key parameter for body monitoring. The temperature sensor allows you to measure this key parameter for body monitoring. Its measure the human body temperature with a 0.1 ºC maximum desviation. The...

MCP2542 is designed specifically for high-speed CAN FD applications with communication speeds of up to 8 Mbps. Longer than usual BUS lengths are supported thanks to the improved maximum propagation delay. The board has a standard RS232...

Arduino-based PLC It has 20 digital inputs / outputs.ARDBOX product family offers the possibility of communication between two computers using I2C obtaining a master-slave connection. Basic Controllers family offers the possibility of...

Fly high with your ultimate IoT platform Get ready to fall in love with the HummingBoard – a small and powerful, low-cost ARM computer that ignites the imagination. Whatever your dream is, the HummingBoard will help make it happen – the...

RTD click is based on MAX31865 resistance to digital converter from Maxim Integrated , optimized for platinum resistance temperature detectors, or RTD. The click uses the PT100 type platinum probe for temperature measurement. There are...

Thermo J click is a temperature measurement click board™, which uses a thermocouple type-J probe, connected to a PPC-SMP-J onboard connector. The active part of the Thermo J click is MCP9600 by Microchip - a thermocouple EMF to...

DHT22 2 click is used for measuring the environmental temperature and relative humidity. It uses the CM2322 sensor, with very accurate thermal and humidity measuring capabilities. It can use either 1-Wire or I2C protocol to communicate...

Proximity 3 click is an intelligent proximity and light sensing device, which features the VCNL4200 sensor from Vishay - high sensitivity long distance proximity sensor (PS), ambient light sensor (ALS) and 940 nm IRED, all in one small...

Microwave click detects movement, thanks to the PD-V11 a 24GHz microwave motion sensor. The typical use for Microwave click is a proximity or motion detector in various applications and devices. The Microwave click can detect movement or...

Water Detect click is used for detecting water and other electroconductive liquids. If the detection area is wet the output of Microchip's MCP606 CMOS op-amp will go positive, signaling the presence of liquid. Water Detect click can be...