This add-on board makes it easy to control two high-power DC motors with a Raspberry Pi. Its twin discrete MOSFET H-bridges support a wide 6.5 V to 30 V operating range and are efficient enough to deliver a continuous 18 A without a heat...

The D24V10Fx family of step-down voltage regulators features the Intersil ISL85410 1A synchronous buck regulator and generates lower output voltages from input voltages as high as 36 V. They are switching regulators (also called...

Overview The Pololu step-up/step-down voltage regulator S10V4F5 is a switching regulator (also called a switched-mode power supply (SMPS) or DC-to-DC converter) with a single-ended primary-inductor converter (SEPIC) topology. It takes an...

The VL6180X from ST Microelectronics is a sensor that combines proximity ranging and ambient light level measurement capabilities into a single package. This board is a carrier for the VL6180X, so we recommend careful reading of the...

This M3 hex nut is made from steel, is zinc-plated, and comes in packs of 25.

This #2-56 hex nut is made from steel, is zinc-plated, and comes in packs of 25.

This force-sensing resistor (FSR) from Interlink Electronics is a passive component that acts as a variable resistor, with resistance decreasing in response to increasing applied force, which makes it easy to add a touch interface to...

This is a bulk-packaged version of our A4988 Stepper Motor Driver Carrier that ships with male header pins installed . Please see that product’s page for more information about the driver. This version requires a minimum order quantity...

DESCRIPTION This board is a compact (0.4″ × 0.8″) carrier for ST’s LPS25H MEMS absolute pressure sensor, or barometer; we therefore recommend careful reading of the LPS25H datasheet (1MB pdf) before using this product. The LPS25H is a...

This switching regulator uses the SEPIC topology to produce 9 V from input voltages between 2.5 V and 18 V. The wide input range coupled with its ability to convert both higher and lower input voltages makes it useful for applications...

This array of IR LED/phototransistor pairs is great for precisely identifying changes in contrast/reflectance (like line-detection). It operates from 2.9 V to 5.5 V and offers dimmable brightness control independent of the supply...

This array of IR LED/phototransistor pairs is great for precisely identifying changes in contrast/reflectance (like line-detection). It operates from 2.9 V to 5.5 V and offers dimmable brightness control independent of the supply...