The TCA9546a is a quad bidirectional I2C multiplexer, providing a single I2C Input and 4 selectable I2C outputs, controlled by the I2C bus. On Power-up, all 4 I2C outputs are disconnected. A 5th I2C output acts as a pass-through from the...

This I2C Multiplexer is an ideal solution for speaking to our entire range of Mini Modules and I2C devices, effectively converting a single I2C port into 8 I2C ports. On-board high-power driver is capable of delivering up to 5 Amps of...

The P82B715TD I2C Range Extender Signal Conditioner is designed to extend the effective range of the I2C Bus from a few feet to a guaranteed minimum of 100 ft when using compatible cable* with a maximum operating speed of 400KHz. We ship...

ZigMo_PCB ZIGMO Wi-Fi/Bluetooth Configuration Kit Configure Passwords of Wi-Fi & Bluetooth Modules NCD Exclusive USB Connectivity for More Reliable Communication Easy KFX Key Fob Configuration Use the ZigMo_PCB to configure KFX Key Fob...

– External antenna – RF cable assemblies RP-SMA (Female) JK-IPEX MHF U.FL 1.13 100MM – RP-SMA (Male) Tilt Swivel 1/2 Wave Whip antenna NOTE: Using the LoRa/Sigfox radio without the external antenna can lead to damage of the device and is...

This is a 3″ Pigtail antenna adapter with a U.fl connector on one side an a RP-SMA connector on the other. This is typically used to connect NCD communication modules to antennas.

ZigBee Wireless Communication Mesh Networking is simply the hottest wireless technology of our time. Period. It’s fast, it’s very easy to use, highly reliable, and self healing. Three components are required for the ZigBee Mesh Network,...

802.15.4 Wireless Modem 802.15.4 Modem make Wireless Control EASY Plug In, Open the COM Port and Start Sending Commands Wireless Control is as Easy as Talking to a USB Port on Your Computer! Wireless Communication Communicating with a...

900HP-S3B Wireless Modem 900HP-S3B Modem make Wireless Control EASY Plug In, Open the COM Port and Start Sending Commands Two Miles of Wireless Control From the USB Port on Your Computer! Wireless Communication Communicating with a...

The RSIO-F6 includes a small RSIO circuit board with a DB-9 Female RS-232 Connector and a 6″ (152mm) flexible ribbon cable. The RSIO-F6 also includes a 2.1mm center positive power supply connector. The RSIO-F6 is used with a few of our...

The RSIO includes a small RSIO circuit board with a DB-9 Female RS-232 Connector and a set of 5 prongs for connection to many of the Legacy Series controllers. The RSIO also includes a 2.1mm center positive power supply connector. The...

The RSB Serial Booster was designed to drive up to 20 optoisolated NCD devices from a single RS-232 serial port with a DB9 connector. The RSB has been tested to drive RS-232 signals at 1000+ feet at data rates up to 38.4K baud. Simply...