• Self piercing • 1/4" Compression fitting • Works with copper and plastic pipe

Reads RGB (24-bit) CIE (xyY) LUX (0 – 65535) Proximity (2 – 36cm) Features programmable color matching proximity triggering onboard LEDs Connector 5 lead data cable Response time 400ms Sensing area 15° half angle Cable length 1 meter...

With your smartphone’s high-definition camera, accurately capturing a color in 8-Bit RGB or CIE might seem straightforward, but it’s quite intricate. The Atlas Scientific EZO-RGB-P sensor, however, simplifies this task. Housed in...

Flow rate 0.5ml to 105ml/mins Accuracy +/- 1% Modes of operation Continuous dispensing Volume dispensing Constant flow rate Dose over time mode Connector 5 lead data cable Calibration Single point Supplied tubing 15.24 cm Tubing size Any...

Reads Total flow and flow rate Preprogrammed Works with all Atlas Scientific flow meters Programmable Can work with most off-the-shelf flow meters Visual display Real time turbine rotation Data protocol UART & I2C Default I2C address 104...

This simple and affordable quadrature-output encoder fits onto the rear shaft of a motor so its position and velocity can be monitored. There are so many projects that require motor position control that Phidgets decided to make an...

Add 4 digital inputs to your VINT Hub. These inputs have a shorter trigger time than a VINT port in Digital Input mode. If you need to expand the number of digital inputs on your VINT Hub, this module provides four extra inputs at...

This carrier board is a great way to connect to an Atlas Scientific circuit neatly, eliminating the need of a bread board. The Female BNC can be replaced with a terminal block (included) if needed. • Through hole soldering ( assembly...

Add 4 isolated active-high digital inputs to your hub at the cost of only one VINT port. Looking to add some serious digital inputs to your VINT Hub ? This module has four active-high digital inputs ideal for reading switches, buttons,...

• No wiring, no bread boards • No soldering necessary, comes fully assembled • Attach up to 5 EZO ™ devices. • Works with EZO-PMP ™, EZO-CO2 ™ and the EZO-RGB. • Built in electrical isolation means that sensors won’t interfere with each...

This powered 7-port USB 2.0 hub is ideal for projects that use multiple USB Phidgets. So many USB devices, so few ports. With this USB hub for your VINT SBC, you'll have access to seven high-speed USB 2.0 ports. You can also use this USB...

With eight analog ports, you can connect a bunch of 5V sensors or measure small voltage signals. For applications where you just need a lot of sensors, the 8x Voltage Input Phidget adds eight 0-5V analog inputs to your VINT Hub . (See...