Control the position, velocity, and acceleration of a stepper motor from your VINT port with this powerful controller. Get moving with this powerful Bipolar Stepper Phidget. With a maximum power supply of 30V, it can provide up to 4A of...

Control 8 DPDT mechanical relays, switching up to 250VAC/2amp or 200VDC/2amp. The PhidgetInterfaceKit 0/0/8 provides small signal relays with 8 relay outputs, rated at a combination of 250VAC, or 2 Amps, up to a maximum of 60 Watts....

• No assembly required • Mounts in seconds • Holds four standard size probes • Holds four PT-1000 temperature probes, or four 1/4" tubes • Holds one 1/2" tube • Padded probe holders prevent breaking • Seriously, this product is really good

The Basic USB to Serial Converter is a very useful tool that allows you to connect your Atlas Scientific circuits to your computer. • LED’s indicate RX and TX communication • Rapid calibration and debugging • 2 different output voltages...

• Expand a single UART (RX/TX) serial port into 8 additional serial ports • On-board LEDs indicate which channel has been opened • Supports baud rates greater then 1M Baud • Easily connect two Serial Port Expanders together to get 16...

• Water proof / fully submersible • Provides years of protection • Hand moldable - stays flexible at extreme temperatures • Forms easily to odd shaped connectors • Non-conductive • Non-contaminating • 1.524m x 12.7mm (60" x 0.5") • A...

Specification Data input UART, I2C and SMBus Max data rate 1 MHz Output voltage 3.9V ± .07 Voltage input 3.0V − 5.0V Power saving EN pin Current consumption 5V – 15 mA 3.3V – 20 mA Circuit dimensions 13.97mm x 20.16mm (0.55″ x 0.79″)...

Replaced by 1012_3 Use it to check the state of switches and push buttons, and/or to switch relays, solenoids, and LEDs. Digital Inputs The Digital Inputs are activated by an external voltage source, triggering on a wide voltage range: 4...

This board has 4 SPDT mechanical relays rated at 210W for DC or 1750VA for AC. The PhidgetInterfaceKit 0/0/4 allows you to control high power devices such as incandescent light bulbs, fans, and pumps by electronically switching power on...

The Phidgets workhorse. Connect sensors, control outputs, and read in digital inputs. Analog Inputs The analog inputs are used to measure continuous voltage outputs generated by various sensors such as temperature, humidity, position, or...

Read and write to RFID tags up to 6cm away. Supports EM4100 series, ISO11785 FDX-B and our own PhidgetTag protocols. The PhidgetRFID Read-Write reads RFID tags that are brought in close proximity to the reader and returns the tag...

This board has 2 SPDT mechanical relays rated at 210W for DC or 1750VA for AC. The Dual Relay Board allows you to control larger loads and devices like AC or DC motors, electromagnets, solenoids, and incandescent light bulbs. Note: This...