Products from DF Robot (DFR)

Attention: It is ideal to use with a LattePanda V1.0 (NOT compatible with LattePanda Alpha/Delta). This is an omni-directional antenna with an IPEX connector. Its working frequency is 2.4GHz which meets most requirements of Wi-Fi...

This 5MP Night Vision Camera for Raspberry Pi is compatible with every version of Raspberry Pi, and comes with infrared lighting. It has infrared night vision mode, and the focus ring can be adjusted according to the position of objects....

The camera for Raspberry Pi can be used to take high-definition video, as well as stills photographs. It’s easy to use for beginners, but has plenty to offer advanced users if you’re looking to expand your knowledge. There are lots of...

Expansion Shield x400 for Raspberry Pi B+/2B/3B/4B is discontinued now, we recommend Expansion Shield x600 as a suitable replacement. The X400 Expansion Shield is a highly cost-effective audio hat which fits on the GPIO of the Raspberry...

You must have used a GPS receiver. It is easy to be found in most places, such as smartphones, cars, and computers. They are used to track your loaction all over the globe. GPS Receiver for Arduino is a unit embedding GPS module and...

Here comes DFRobot's new Analog Ambient Light Sensor for Arduino or Raspberry Pi. Brand new design and much more convenient to use. This sensor help you to detect the light density and reflect the analog voltage signal back to Arduino...

DFRobot’s Expansion Shield for Intel® Joule™ is a powerful add-on component to the Intel® Joule™ compute module with its carrier Expansion Board for Intel® Joule™. Other than what is originally supported by Intel® Joule™ and the...

INTRODUCTION PYNQ-Z2 is a FPGA development board based on ZYNQ XC7Z020 FPGA, intensively designed to support PYNQ, a new open-sources framework that enables embedded programmers to explore the possibilities of xilinx ZYNQ SoCs without...

INTRODUCTION DFRobot Gravity: analog electrical conductivity meter V2 is specially used to measure the electrical conductivity of aqueous solution, and then to evaluate the water quality, which is often used in water culture,...

INTRODUCTION This is a water pressure sensor adopts DFRobot Gravity 3-pin interface. It supports standard 5V voltage input and 0.5~4.5V linear voltage output. It is compatible with multiple Arduino controllers. Coordinate with a DFRobot...

INTRODUCTION This EMG sensor is launched by the cooperation of DFRobot and OYMotion, which can detect sEMG to reflect muscle and neural activities of human. This sensor integrates filtering circuit and amplified circuit. It amplifies...

INTRODUCTION This is an Arduino compatible sound level meter(also known as decibel meter, noise meter). It uses instrument circuit and low noise microphone, which enable it to accurately measure the sound level of the surrounding...