Products from Atlas Scientific

• This temperature thermowell is used to protect temperature probes placed in systems with high pressure or flow. • 30mm thermowell extension • Temperature range: -273°C to 1300°C • Threading: 1/2" NPT • Material: 304 stainless steel •...

• This temperature thermowell is used to protect temperature probes placed in systems with high pressure or flow. • 100mm thermowell extension • Temperature range: -273°C to 1300°C • Threading: 1/2" NPT • Material: 304 stainless steel •...

Specification • 1 IXIAN™ Conductivity Transmitter • 1 Industrial Conductivity Probe K 1.0 • 3/4″ NPT pipe thread on input and output side • 2 250ml (8oz) calibration solutions K 1.0 – This set includes 1 (1,413µS) and 1 (12,880µS) Probe...

Those of us who work with PLCs clearly understand both the power and limitations of industrial computers. Modern low voltage elections and communication protocols aren’t easily compatible with PLCs. Fortunately, the Atlas Scientific...

Reads Conductivity Range 5 − 200,000μS/cm Accuracy +/ – 2% Connector Tinned leads Response time 90% in 1s Max pressure 200 PSI Max depth 60m (197 ft) Temperature range °C 0 − 110 °C Cable length 3 meters Pipe fitting 3/4" threaded NPT...

Over the years, we have tested an endless number of conductivity probe designs. Our research has shown us that not all conductivity probes are the same. Many lower-quality probes are susceptible to “fringe effect,” which makes the...

This Conductivity Probe can be fully submerged in fresh water or salt water, up to the BNC connector indefinitely. Reads Conductivity Range 5 − 200,000 μS/cm Accuracy +/ – 2% Connector Male BNC Response time 90% in 1s Max pressure 3,447...

Reads Conductivity Total dissolved solids (ppm) Salinity = PSU (ppt) 0.00 − 42.00 Range 0.07 − 500,000+ μS/cm Accuracy +/ – 2% Response time 1 reading every 640ms Supported probes K 0.01 – K 600 any brand Calibration 1 or 2 point Temp...

Over time Conductivity Probes can become dirty and covered in mineral deposits. This can change the basic electrical properties of the probe and cause inaccurate readings. Cleaning the probe can be a bit tricky; you can’t simply scrub it...

Reads Gaseous CO2 Range 0 − 10,000 ppm Calibration Factory calibrated Response time 1 reading per second Resolution 1 ppm Accuracy +/- 3% +/- 30 ppm Connector 5 lead data cable Warmup time 10 seconds Cable length 1 meter Data protocol...

The PT-1000 can be fully submerged in fresh water or salt water, up to the BNC connector indefinitely. • 1 EZO™ RTD Temperature Circuit • 1 Temperature Thermowell (choice of 100mm, 50mm or 30mm) • 1 PT-1000 Temperature Probe with BNC...

Datasheets EZO™ Dissolved Oxygen Circuit Datasheet Lab Grade Dissolved Oxygen Probe Datasheet Electrically Isolated EZO™ Carrier Board Datasheet Documents Wiring Diagram Connecting probes into a pipe How to properly cut your probe cable...