This is a simple three wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST connector on one end, bare cable on the opposite end. It also comes with the mating connector for the JST....

This is an Chasing EL Wire Adapter Cable, a simple connector that splits up the four wires in a Chasing EL wire allowing them to be individually powered or controlled. On one side of this cable is a 4-pin JST SMP connector that can be...

EL wire, or electroluminescent wire, is a flexible wire coated in phosphor. Apply the appropriate voltage and it lights up! Each EL wire looks a lot like a thin flexible neon tube and they come in many bright colors which can be driven...

These DC powered heating pads are perfect for near-body heating applications. They get warm to the touch but not too hot as long as you provide the appropriate voltage. Simply apply 5VDC to the wire leads and within minutes, the pad will...

EL wire, or electroluminescent wire, is a flexible wire coated in phosphor. Apply the appropriate voltage and it lights up! Each EL wire looks a lot like a thin flexible neon tube and they come in many bright colors which can be driven...

This is the Sunny Buddy, a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger provide you with the ability to get the most possible power out of your solar panel or other...

Description This black fiber optic fabric is a cool and unique way to add some shine to your e-textiles project. There are optical fibers actually woven into this piece of fabric! Simply shine a bright light into the fiber bundle, which...

This is the Standard Gripper Kit B, a simple and durable robotics kit that is great for “getting a grip” on pretty much any robotics project! Designed for use with any standard size Hitec or Futaba servo, the gripper kit is easy to...

Fingerprint scanners are awesome. Why use a key when you have one right at the tip of your finger? Unfortunately, they’re usually unreliable or difficult to implement. Well not anymore! We’ve found this great fingerprint module from...

900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 105mm long. The FCC is moving towards Part 15 compliance. All this means is that all the SMA RF connectors are...

For over 50 years, Hakko has been producing superior quality soldering and desoldering tools. They’re dependable, a good value and they work really well! We use Hakko irons in production and we think they’re great. The Hakko FX-888D is...

This is a replacement soldering tip for our Hakko FX-888 soldering iron. This is a bevel type of soldering tip. Replacing the tip is very easy - simply unscrew the shield, slip the replacement tip in, and screw the shield back on.