Duplicator 4X - Dual Extrusion 3D Printer

The Duplicator 4X is our first dedicated 1.75 mm filament extruder. This extruder was designed from scratch, and contains a number of custom manufactured parts. We’ve learned a lot over our past extruder designs, and incorporated a lot of those lessons here: that’s why it’s smaller, lighter, and faster to build. And since it’s designed from the ground up for 1.75 mm filament, it’s light-years ahead of past designs in small-filament reliability.The layer alignment is much better which results in nicer prints and higher resolution, 100 micron inch

We’ve completely overhauled the drive system to give the optimum positioning accuracy. The entire system has been upgraded to sturdy 3/8″ diameter linear shafting. This is probably overkill, but you can trust that the axes will be sturdy. We’ve also switched to self-aligning, sintered stainless steel bearings. These are very forgiving to DIY assembly and provide a nice, smooth motion on the steel shafts. We’ve completely replaced the Z axis with a stepper driven, cantilevered stage. Guided by two of the linear shafts, this completely eliminates any Z wobble and results in nicely aligned layers. Using a high-angle lead screw, we were able to increase the speed of the Z axis from 150mm/minute to 1,000mm/minute. This means the layer changes are almost completely imperceptible.

Connect over USB and hit print — the machine will calibrate itself and start printing. It will automatically home itself, heat up, and begin printing. You can even print with an SD card if you wish to. Don't limit your prints to pint sized objects, print objects as large as a coffee mug all with the new Duplicator 4!

This is the latest model and comes with a latest dual extruder MK9 motors.

What's in the box-

1. Duplicator 4X - Dual Extrusion 3D Printer
2. 2kg PLA Filament 1.75mm [Please leave your color request in comments while placing order.]
3. Preloaded SD card - 2Gb
4. Instrucation Manual
5. Masking tape.

General Information

Supported Materials: PLA , ABS
3D Printing Process: Fused Deposition Modeling (FDM)
Build Dimensions: 225 x 145 x 150 mm
Printer Dimensions: 320 x 466 x 382 mm
Weight: 17 kg

Performance

Min Layer Height: 100 microns
Max Print Speed: 40 mm/s

Hardware

Filament Diameter: 1.75 mm
Nozzle Diameter: 1 0.4 mm
Heated Bed/Build Area: Yes
Number of Heads: 2

Other

Open Source: Yes

P.S - In stock printers will be shipped with PLA 1.75 mm - Red and PLA 1.75mm - White.

For custom Filament color requirement lead shipping time is 10-15 days. You can also choose to buy from our range of filaments here.