Top seller
No results were found for the filter!
NEW
Power Distribution Board (PDB) 60A This Power Distribution Board (PDB) is used for PM02, PM02D Power Module. Power modules with build-in power distribution such as the PM03, PM06, PM07 would not require this PDB. There are two options, with or without XT30 pre-soldered....
₹ 629.00 *
NEW
Tekko32 F4 4in1 Mini 50A ESC(AM32) Feature: All new High-quality MOSFETs with low internal resistance & heat generation, and individual metal heatsink New and faster F4 MCU @ 150Mhz (compared to F3 @108Mhz & F0 @48Mhz) Separate drive & control circuit, reducing the...
₹ 8,699.00 *
NEW
Kakute H7 Mini v1.5 (ICM-42688) The Holybro Kakute H7 Mini is a Flight Controller full of features, including onboard VTX ON/OFF Pit Switch with battery voltage, HD System/VTX & 4in1 ESC plugs, barometer, OSD, 6x UARTs, easy soldering layout, and much more. The Kakute...
₹ 6,099.00 *
NEW
Pixhawk 6C (Aluminum Case) The Pixhawk® 6C is the latest update to the successful family of Pixhawk® flight controllers, based on the Pixhawk® FMUv6C Open Standard and Connector Standard. It comes with PX4 pre-installed. Inside the Pixhawk® 6C, you can find an...
₹ 20,999.00 *
NEW
Pixhawk 6X (ICM-45686) FC Module Only Key Design Points Redundancy: 3x ICM-45686 IMU sensors ( ±32g) with BalancedGyro™ technology & 2x Barometer sensors High-performance STM32H753 Processor with a clock speed of up to 480 MHz Modular flight controller: separated IMU, FMU,...
₹ 15,999.00 *
NEW
PM02D Power Module(2S-12S) Description PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a...
₹ 2,499.00 *
Pixhawk Mini Baseboard These Pixhawk baseboards can be used with Pixhawk 6X, 5X, and any flight controller that follow the Pixhawk Bus Standard. Pixhawk Standard Baseboard v2A & V2B Ports can be found here Pixhawk Standard Baseboard v1 Ports Pinout can be...
₹ 11,999.00 *
PM07 Power Module (14S) This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal...
₹ 5,619.00 *
UBEC 12A (3-14S) UBEC 12A (3-14S) is a synchronous step-down regulator from a high voltage or widely varying input supply. It draws the DC voltage from a 3-14S LiPo battery and drops the voltage to a level suitable for receivers and other electronic...
₹ 4,199.00 *
X650-Tekko32 F4 45A ESC Tekko32 F4 45A ESC is the latest BLHeli32 ESC from HolyBro. The Tekko32 ESC runs in conjunction with an ARM 32bit compatible F4 MCU. It can run input signals with lower latency, at faster rates, smooths out the RPM band, is capable of...
₹ 3,989.00 *
Power Distribution Board (PDB) Board (With XT30... This Power Distribution Board (PDB) is used for PM02, PM02D Power Module. Power modules with build-in power distribution such as the PM03, PM06, PM07 would not require this PDB. There are two options, with or without XT30 pre-soldered....
₹ 1,099.00 *
Holybro BLHeli S 20A ESC Holybro 20A ESC is compatible with X500 and also offers PMW,Oneshot,DSchot and MiltiShot. Features EFM8BB21F16G MCU, 8-bit C8051 core with pipelining and a maximum operating frequency of 50 MHz. Dedicated high frequency driver maximum...
₹ 1,739.00 *
Pixhawk 6C H-Flow Optical Holybro BLHeli SiK Telemetry Pixhawk 6X Kakute H7 Mini Power M10 GPS Holybro Depth Pixhawk 6X-RT Holybro X500 V2 Holybro X650 PM07 Power Holybro 1045 UBEC 12A 3-14S Micro M10 GPS SiK Telemetry S500 V2 Frame H-RTK F9P Pixhawk 6X Pro Pixhawk 6C Tekko32 F4 4in1 Holybro X500 V2 Holybro X500 V2 Pixhawk 6X SiK Telemetry Holybro M9N GPS Kakute H7 v1.3 Kopis X8 X650-Tekko32 F4 M9N GPS Kakute H7 v1.3 PM02D Power Pixhawk Mini X500 V2 Frame H-RTK F9P Base Pixhawk 6C Power Holybro X650 X650 Frame Kit Pixhawk Jetson Pixhawk 6C
Viewed