Features Pre-Assembled Female BNC Connector Low profile Gold plated Brass Includes washer and nut Designed for RF applications Right angle 50ohm impedance Designed to be easily connected into a breadboard for rapid development.

• No assembly required • Mounts in seconds • Holds four standard size probes • Holds four PT-1000 temperature probes, or four 1/4" tubes • Holds one 1/2" tube • Padded probe holders prevent breaking • Seriously, this product is really good

The Basic USB to Serial Converter is a very useful tool that allows you to connect your Atlas Scientific circuits to your computer. • LED’s indicate RX and TX communication • Rapid calibration and debugging • 2 different output voltages...

• Expand a single UART (RX/TX) serial port into 8 additional serial ports • On-board LEDs indicate which channel has been opened • Supports baud rates greater then 1M Baud • Easily connect two Serial Port Expanders together to get 16...

• Water proof / fully submersible • Provides years of protection • Hand moldable - stays flexible at extreme temperatures • Forms easily to odd shaped connectors • Non-conductive • Non-contaminating • 1.524m x 12.7mm (60" x 0.5") • A...

Specification Data input UART, I2C and SMBus Max data rate 1 MHz Output voltage 3.9V ± .07 Voltage input 3.0V − 5.0V Power saving EN pin Current consumption 5V – 15 mA 3.3V – 20 mA Circuit dimensions 13.97mm x 20.16mm (0.55″ x 0.79″)...

• BNC male to BNC female • 30 meters (100') • 430 Stainless Steel • Teflon™ • RG179 cable • 75 ohm impedance • Food safe • Max Temperature Rating: 200° C • Jacket diameter: 0.100 inch +/- 0.005 • Works with all Atlas Scientific probes

• BNC male to BNC female • 3 meters (10') • 430 Stainless Steel • Teflon™ • RG179 cable • 75 ohm impedance • Food safe • Max Temperature Rating: 200° C • Jacket diameter: 0.100 inch +/- 0.005 • Works with all Atlas Scientific probes

BNC panel mount kit comes with : • 1x Rubber gasket (choice of color) • 1x BNC bulk head • 1x Hinged cover • 1x BNC cable (male to male) • 1x Template sticker • 2x Mounting screws • 2x Brass couplings BNC cable specs : • 15.8cm (6.25") •...

• No assembly required • Mounts in seconds • Holds three standard size probes • Holds two PT-1000 temperature probes, or two 1/4" tubes • Padded probe holders prevent breaking • Seriously, this product is really good

Electrically Isolated USB EZO™ Carrier Board Allows you to connect your Atlas Scientific circuit directly to your computer or Raspberry Pi, using standard USB drivers (for an FTDI device). Built in isolation ensures that your circuit...

This carrier board utilizes the newest isolation technology, giving us the ability to put isolation into smaller footprint circuits. The Electrically isolated EZO™ carrier board is an efficient way to connect to one Atlas Scientific...